The PSD-TS60 60" dual post floor stand adapter is designed to mate directly with any of Premier Mounts flat or tilting PDM series plasma wall mounts in the horizontal or vertical display mode. The dual 2" chrome steel posts allow for full-length height adjustability with positive locking of the set height. Optional flat accessory shelf or enclosed lockable support equipment housing can be installed above or below the display in a front or rear-facing mode. Multiple power and signal cable slots are available in each chrome post to run cables within the tubes. Constructed of heavy gauge steel the flat steel base plate is a wide 36" x 30" deep to insure the stability of the display mounted stand. Four 3/8" holes are available (one at each corner) of the base plate for additional security if needed to secure the base to the floor structure. Setup is easy with only a hex key (supplied) and a flat blade screwdriver. This stand adapter is designed for two displays.
1.800.814.5410 
858.764.8900 Mon-Fri 6AM-4PM PT
